Launch X431 ECU & TCU Programmer Clone VW MG1CA811

This is a demo on how to use Launch X431 ECU & TCU Programmer to clone Volkswagen MG1CA811 ECU on bench. Prepare an original ECU and a new one/or a second-hand module, follow the steps below to start cloning.
launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(1)

Open X431 ECU & TCU Programmer software,
Search MG1CA811
Make: Skoda
Model: Fabia 2006-2020
Engine: DFNB 998 67
ECU: MG1CA811 SPC58

Select “Direct connection of diagram” to check the wiring diagram.
After a successful connection, click “Connect”.
launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(2)

launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(3)

launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(4)

Click “Read EEPROM data”.
Reading EEPROM success.
Save the EEPROM data file.

Click “Read FLASH data”.
Reading FLASH success.
Save the FLASH data file.
launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(5)

launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(6)

Disconnect to reconnect with another ECU.
Click “Connect”.
Backup EEPROM data.
Backup FLASH data.
Write EEPROM data >> Load the saved file
Writing EEPROM success.
Write FLASH data >> Load the saved file
Writing FLASH success.

Clone VW/Skoda MG1CA811 ECU success.
launch-x431-ecu-tcu-programmer-clone-vw-mg1ca811-(7)

www.obd2shop.co.uk

 

About Sales OBD2shop.co.uk 2264 Articles
OBD2shop.co.uk specializes in manufacturing and exporting car & truck OBD OBD2 EOBD diagnostic tools to worldwide.