How to use Obdstar X300 DP Plus key programmer to add new blade key for 2009 VW Passat via OBD successfully?
Now let’s connect to the vehicle OBD2 interface and show the steps.
Go forward to Obdstar X300 DP Plus scanner:
IMMO >> Search Bar, input VW >> VW/AUDI/SKADA/SEAT V34.41
VW >> 2-3.5 Generation Immobilizer>> Select From Type >> Read PinCode >> 17 Dashboard >> 2-3 Generation
Switch ignition off, press “Enter”.
Switch ignition on, press “Enter”.
Record the password, press “Enter”, then “Esc” back to “25 Immobiliser”.
Follow the prompts to operate:
The screen says to switch ignition off again, then press “Enter”.
Switch ignition on again, press “Enter” to go on.
If there is a key to start the vehicle, insert it into the ignition and turn to ON position first.
Enter >> Enter Password >> Enter >> Successful
Enter the key number to match >> Enter
Each key in the ON/OFF position for at least 2 seconds, matching is done.
Note: if the remote can remotely control the vehicle but cannot start the vehicle, the instrument prompts IMMOBIL ACTIVATED, then re-insert the key without turning on the ignition, wait for a few minutes and try to start!
3 keys have been programmed successfully, don’t forget to test them the remote control function.
Obdstar X300 DP Plus no merely supports VW key programming function, but supports mileage programming function as well. More function tests to be continued…