This is a guide for you to use Yanhua Digimaster 3 + solderless adapter for mileage adjustment. Including installation and operation step by step.
How to install Yanhua D3 & solderless adapter?
1. Connect Digimaster 3 and Yuanhua solderless adapter via a power cable.
2. Connect the chip and Yuanhua solderless adapter via chip clip or Puncture socket. The red line needs to match Pin1 of the chip.
3. Select the corresponding chip model through “CHOOSE” on the adapter:
My dashboard computer here is a 2009 VW Bora, chip no. 24C32. So I gonna choose 24XXX, then press test, and start pin detection.
*If the pin detection fails, please adjust the chip clip and press the test again.
4. When pass the pin detection, connect the adapter and Digimaster 3
How to use Yanhua D3 for mileage correction?
Meter system >> Europe >> Volkswagen >> Bora >> 18G920826 >> 2009 and next
Check the original mileage, and press “YES”.
Save the original data.
Now we can program new mileage.
Enter the new mileage value, then choose “OK”.
Mileage adjustment is successful.
Complete.
