One of Xtool KC501 functions is to Read Write MCU / EEPROM Chips. Here we go on how to operate.
Let’s go!
First, Connect USB with PC
Check the light
Red Light on standby mode
Green Light on Data Transmission
1. Read/Write Atmel AT24C01A Chip
Then, Open the chip lock socket lever and put it into the chip according to align with the pin.
Open software in PC, “Successfully Connected” will be shown:
2. Read/Write EEPROM – Atmel – AT24C01A Chip
Write data into the chip
3. Can Read/Write/Erase 7 kind of Freescale’s MCU
Connect chip In terms with the below diagram, have it connect with KC501.
Same type of chip may have a different pin number, e.g. 80PIN, 112PIN,144PIN…
4. Xtool KC501 supported ECU:
Warning: Please turn off the power when connecting the ECU, turn on 12V power after its connected. Read/Write MCU could be a reference when doing Read/Write the chip here.
Enjoy!