This is an operation guide on using Yanhua Digimaster 3 + MEM ICP solder-free programming adapter for mileage correction. Read this article to learn how to do it.
Accessories
MEM-ICP adapter
3M fixed piece
Solder-free programming bracket
8PIN chip clip
14PIN cable
Yanhua Digimaster III
Odometer module
Check the video to learn:
Installation
1. Confirm the location of the standard 8-pin EEPROM chip and crystal. Select an appropriate position to fix the 3M piece according to the crystal position and bracket length.
2. When crystal pin spacing is > 5mm, install the solder-free bracket to the A column. When crystal pin spacing is < 5mm, install the solder-free bracket to the B column(In this case, install it to the A column).
The white probe is removable that can be used to short the crystal in different packages(In this case, adjusted it to 12).
3. Connect the 14PIN cable and 8PIN chip clip, and install a solder-free bracket. Adjust the angle, and shorten the crystal. Please note that the red line means PIN-I. Clamp the 8-pin chip, and connect the MEM-ICP adapter with the 14PIN cable. Then connect the adapter to Digimaster III.
Operation
Select an option based on car and chip model:
Instrument system >> Japan&Korea >> Subaru >> Outback >> 2006 >> Confirm chip model is 93C56, click Next >> MEM-ICP
You can drop down the help image to guide the connection. As you can see, green indicates that the 8-pin chip and the crystal are well connected. Click “OK”.
Confirm the current mileage, and click “OK”.
Save the original file.
Enter the new mileage, and click “OK”.
Write data success.
