Learn how to program the 2024 Nissan Rogue all keys lost using the Lonsdor K518 PRO Key Programmer via OBD. This step-by-step tutorial covers BCM connection, key ID reading, and smart key programming for a complete vehicle restart.
Tools Required
Lonsdor K518 PRO
NISSAN 40PIN-BCM Cable
2024 Nissan Rogue
A New Key
Immo & Remote >> NISSAN >> Select from vehicle >> North America >> Rogue >> 2021-2023 >> Smart key(PUSH button) >> All smart key lost
This function requires unplugging the BCM connector, then using the Nissan-40 Specific Cable to connect the BCM, and pressing OK to continue.
All keys of this vehicle must be reprogrammed. Press OK to continue.
Turn the ignition off.
Turn on Hazard warning lights;
Stay at P or Neutral gear;
The steering column is in the unlocked state.
Press OK.
Start to read the key ID:
Place a smart key (to be programmed, with the logo facing upwards) flat on the ignition switch, ensuring the key’s logo end is directly aligned with the ignition.
Note:
1. Do not move the key from the ignition.
2. Do not press any button.
3. Do not insert or remove the little mechanical key from the key.
Press OK.
Count of new keys: 1
Count of old keys: 0
Current key count in total: 1
Here requires to read ID of the keys to be programmed.
Click Cancel to next step.
28-bit PIN has been read out.
It can be used when the program key is on AKL condition!
Start to program the key.
Place a smart key (to be programmed, with the logo facing upwards) flat on the ignition switch, ensuring the key’s logo end is directly aligned with the ignition.
Press OK.
Programmed successfully, press Cancel to complete.
Count of keys programmed successfully: 1
1. In turn to press each key’s Lock and Unlock buttons, and check if it works normally.
2. Check if each key can start the car separately after finishing the above operations. Click OK to end the procedure.
After checking all keys, do not exit this function.
Operate as per the prompts below and click OK:
1. Unplug the connector, reinstall the vehicle’s gateway module.
2. Connect the device to the OBD port, and turn the ignition on.
Test the new key, and all can work well.
Successfully done.
