Good news ! Xhorse VVDI2 V4.3.0 New Released!
Free download V4.3.0 software:
https://mega.nz/#!W1pSRRTL!0n8OX4wshaB1s0O06SDhTR0KvO32nPHZWg4CQjBMdrA
VVDI2 latest software version V4.3.0 update
************************************************ ********************
*** 2017-08-16
*** Require firmware V4.3.0
************************************************ ********************
===== VAG V4.3.0 =====
1. Bugfix
===== BMW V4.3.0 =====
1. Add BMW FEM/BDC system key learning, erase key
2. Add BMW FEM/BDC system reset KM
3. Add FEM/BDC syste backup coding, restore coding
4. Attention: FEM/BDC Key Learn is an option function, it require buy license or exchange with bonus points. Contact your dealer for help!
===== Porsche V4.3.0 =====
1. Bugfix
===== PSA V4.3.0 =====
1. Bugfix
===== Transponder Programmer V4.3.0 =====
1. Bugfix
===== J2534 V4.3.0 =====
1. Bugfix
===== Online Upate Tool V4.3.0 =====
1. Bugfix
===== Quick Start V4.3.0 =====
1. Bugfix
Attention Please:
BMW FEM/BDC system(function released and available, just no user manual)
Users can refer to following information (3 steps for make keys:get key info->programming FEM/BDC system->make keys)
1.support make new key with ignition switch(support add spare key and all key lost, all key lost require ISN)
2.support reset FEM/BDC KM(cluster require reset manually)
3.support erase key(after erase the key position become blank position)
4.support backup coding
5.support restore coding
Notes:
1.backup coding and restore coding can direct operation generally.
2.add keys, reset KM, erase key must programming FEM/BDC system first
3.in FEM/BDC interface, if ‘get key info’ the type not support, it will show:customer should use “BMW E-sys software” program FEM/BDC system.then programming FEM/BDC system with VVDI2-BMW
4.when operation on ‘programming FEM/BDC system’interface,please don’t close this software window until all procedures completed.
5.programming FEM/BDC system, require soldering and get eeprom.(FEM 95128 chip, BDC 95256 chip)usually there are 2 same chips on the module, please refer to the software diagram, select the correct one.
6.programming FEM/BDC system,must restore the original eeprom, restore coding.if cannot restore coding or after restore coding assemble FEM/BDC module back to car,but with problem(such as the remote control cannot start the car
or the car with window problem)please use “BMW E-sys software” coding for FEM/BDC system
7.if connect power to FEM/BDC module, but the relay keep ringing,please contact technical support for help.usually operation on FEM/BDC should be ok,just need to programming.