This is a tutorial on how to use Lonsdor K518 PRO to program the 2022-2024 Toyota Land Cruiser with all smart keys lost by OBD.
Step1. Backup Immo Data
Immo & remote >> TOYOTA >> Select from type >> All smart key lost >> Type 3(2022-) >> 8A >> Backup immo data
Please refer to [Attention] before the operation, use Toyota-FP30 Cable to connect the PEPS case!
Please ensure the device is well connected to the network before operating!
During the use of this function, please do not operate abnormally, or maliciously steal relevant data, otherwise the K518 will be locked and cannot be unlocked.
Please turn the ignition on, if fails, please turn on 2 flashing lights or cycle the emergency flasher 2 times from “ON to OFF”.
K518 PRO will automatically enter the VIN code.
Calculating, please wait…
Enter the file name to save data.
Immo data backed up successfully.
After the backup is completed, please roll back the PEPS case installation, and connect all connections and plugs well.
Step2. Generate Emergency Key
Click “Generate emergency key”.
This function can load backup data to generate an emergency key in an AKL situation, and then you use this key to turn on the dashboard to add keys.
This function requires an Internet connection.
Connect the K518 PRO antenna and place the antenna’s top into the card slot.
Selected the saved immo data file.
Calculating, please wait…
Upgrading APP… please don’t move the key.
Emergency key generation is successful, please step on the car brake once, and use the emergency key to turn the ignition on, then enter the [Add smart key] function menu to add new keys.
Step3. Add Smart Key
Add smart key >> OK
Please keep the vehicle fully charged, in case of faults caused by low battery power!
Please switch the ignition on.
Load the read D-FLASH data of PEPS to acquire a 12-bit PIN code.
Please select D-FLASH data of PEPS, specific operations as follows:
1. Execute [Backup immo data] to read D-FLASH data, then save the data(BIN file) to the CUSTOM FILE directory in this device host;
2. Select the above BIN file saved in the CUSTOM FILE directory, the file size supports 32K;
3. Click OK, and select the file in the next interface.
Count of the registered keys: 2
Count of registrable keys: 5
Hold the registered key’s back closer to the Start button, when the buzzer beeps once, take the key away from the button.
Operation completed!
Count of registered keys: 3
Count of registrable keys: 4
Please turn the ignition off, and check if the key works properly, if it doesn’t have a remote function, please follow the prompts to operate, and click OK to continue.
The new key remote works normally.
Done.