Step by Step How to Program SAAB DDM with GM Tech2 and TIS2000

If you wanna to program the Drivers Door Module (DDM) on your SAAB yourself, you will need a dealer tool, GM Tech2 scanner with TIS2000 software, which can be purchased online to get the job done.

I have a Tech2 scan tool from a UK warehouse whose based in China shipping from Shenzhen,China at the price of 240 GBP .

If you also already have a Tech 2 tool, you can follow the step-by-step guide below and get the DDM programmed.

Equipment needed:

GM Tech 2 diagnostic scanner

32MB PCMCIA Card for SAAB

TIS2000 software (Important ! Without this you would not be able to add anything!)

gmtech2-scanner-1

Detail Steps :

Step 1. Connect GM Tech2 to the OBD port of your SAAB and open the scanner and then go to the main menu.

Step 2. Select “F0 Diagnostics” from the main menu.

gmtech2-scanner-2

Step 3. Select the year of your car. Here I select “2004”.

gmtech2-scanner-3

Step 4. Select model of your car. Here I select “SAAB 9-3 Sport (9440)”.

gmtech2-scanner-4

Step 5. Select “F7: Add/ Remove” in the next page.

gmtech2-scanner-5

Step 6. Select”F1: Control Modules”.

gmtech2-scanner-6

Step 7. Select “DDM” control module in the next page.

gmtech2-scanner-7

Step 8. Select “Add”.

gmtech2-scanner-8

Step 9. Select “Checking Security Access Working” and then turn ignition key to “ON” position.

gmtech2-scanner-9

Step 10. Select “Adding Unit”. Wait the system process to 100% and then drive a test.

gmtech2-scanner-10

Done!

 

(Visited 167 times, 1 visits today)